Canon 0989B001AA Advanced Manual page 49

Advanced Fax Features
1
Faxes do not print.
Advanced Copy
Features 2
System Monitor
3
Reports and Lists
4
Troubleshooting
5
Appendix
6
Table of Contents
Index
Q Have you removed the sealing tape from the
toner cartridge?
A Make sure you remove the sealing tape from the
cartridge. (See "Install Toner Cartridge," in the
Starter Guide.)
Q Is the toner cartridge installed properly?
A Make sure the toner cartridge is installed properly.
(See "Install Toner Cartridge," in the Starter Guide.)
Q Is the cartridge out of toner?
A Replace the toner cartridge. (See Chapter 10,
"Maintenance," in the Basic Guide.)
If you want to print out the received documents
without replacing the toner cartridge, set <CONT.
PRINTING> to <ON> in the <RX SETTINGS> of
the <FAX SETTINGS> menu. The machine
continues printing received documents and reports
although the toner is run out.
Back
Q Is the correct type of paper loaded in the
machine?
A Make sure you load paper that meets the
requirements for use. (See Chapter 3, "Print
Media," in the Basic Guide.)
Received faxes print blotched or unevenly.
Q Are the telephone lines in poor condition, or do
you have a bad connection?
A Error Correction Mode (ECM) should eliminate
such problems. However, if the telephone lines are
in poor condition, you may have to try again.
Q Is the sender's machine functioning properly?
A Ask the sender to check that the scanning
components of the machine are clean.
TOP
Previous Next
5-11