Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 11-05-2007 Installation Manual page 293

chkconfig --add o2cb
When you add a new service, chkconfig ensures that the service has either a
start or a kill entry in every run level.
3 If the ocfs2 service is not already enabled, enter
chkconfig --add ocfs2
4 Configure the o2cb cluster service driver to load on boot.
4a Enter
/etc/init.d/o2cb configure
4b At the Load O2CB driver on boot (y/n) [n] prompt, enter
y
(yes) to enable load on boot.
4c At the Cluster to start on boot (Enter "none" to
clear) [ocfs2] prompt, enter
none
This choice presumes that you are setting up OCFS2 for the first time or re-
setting the service. You specify a cluster name in the next step when you set
up the /etc/ocfs2/cluster.conf file.
5 Use the ocfs2console utility to set up and save the /etc/ocfs2/cluster
.conf file to all member nodes of the cluster.
This file should be the same on all the nodes in the cluster. Use the following
steps to set up the first node. Later, you can use the ocfs2console to add new
nodes to the cluster dynamically and to propagate the modified cluster.conf
file to all nodes.
Oracle Cluster File System 2 275