Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 11-05-2007 Installation Manual page 163

choose another keyboard layout, select the desired layout from the list provided. Test
the layout in Test by pressing keys on the keyboard.
Fine-tune the settings by clicking Expert Settings. Adjust the key repeat rate and delay
and configure the start-up state by choosing the desired settings in Start-Up States. For
Devices to Lock, enter a space-separated list of devices to which to apply the Scroll
Lock , Num Lock , and Caps Lock settings. Click OK to complete the fine-tuning. Finally,
after all selections have been made, click Accept for your changes to take effect.
To set up the keyboard for the graphical environment, run the graphical YaST then select
Keyboard Layout. Find information about the graphical configuration in Section 8.14.3,
"Keyboard Properties" (page 190).
8.4.11 Mouse Model
When configuring the mouse for the graphical environment, click Mouse Model to access
the SaX2 mouse configuration. Refer to Section 8.14.2, "Mouse Properties" (page 189)
for details.
To configure your mouse for the text environment, use YaST in text mode. After entering
text mode and selecting Hardware > Mouse Model, use the keyboard arrow keys to
choose your mouse from the provided list. Then click Accept to save the settings and
exit the module.
8.4.12 Sound
Most sound cards are detected automatically and configured with reasonable values
during initial installation. To install a card added later or modify settings, use Hardware
> Sound. It is also possible to switch the sequence of the cards.
System Configuration with YaST 145