Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 11-05-2007 Installation Manual page 209

without the need for reconfiguration. After you click OK, the changes are applied im-
mediately.
8.14.4 Tablet Properties
Use this dialog to configure a graphics tablet attached to your system. Click the
Graphics Tablet tab to select vendor and model from the lists. Currently, only a limited
number of graphics tablets is supported. To activate the tablet, check Activate This
Tablet at the top of the dialog.
In the Port and Mode dialog, configure the connection to the tablet. SaX2 enables the
configuration of graphics tablets connected to the USB port or the serial port. If your
tablet is connected to the serial port, verify the port. /dev/ttyS0 refers to the first
serial port. /dev/ttyS1 refers to the second. Additional ports use similar notation.
Choose appropriate Options from the list and select the Primary Tablet Mode suitable
for your needs.
If your graphics tablet supports electronic pens, configure them in Electronic Pens.
Add eraser and pen and set their properties after clicking Properties.
When you are satisfied with the settings, click OK to confirm your changes.
8.14.5 Touchscreen Properties
Use this dialog to configure touchscreens attached to your system. If you have more
than one touchscreen installed, each device is shown in a separate dialog reachable by
a tab. To activate the currently selected touchscreen, check Assign a Touchscreen to
Display at the top of the dialog. Select vendor and model from the lists below and set
an appropriate Connection Port at the bottom. You can configure touchscreens connected
to the USB port or the serial port. If your touchscreen is connected to the serial port,
verify the port. /dev/ttyS0 refers to the first serial port. /dev/ttyS1 refers to the
second. Additional ports use similar notation. When you are satisfied with your settings,
click OK to confirm your changes.
System Configuration with YaST 191