Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 11-05-2007 Installation Manual page 133

Configuring Physical Volumes
Once a volume group has been created, the following dialog lists all partitions with either
the "Linux LVM" or "Linux native" type. No swap or DOS partitions are shown. If a
partition is already assigned to a volume group, the name of the volume group is shown
in the list. Unassigned partitions are indicated with "--".
If there are several volume groups, set the current volume group in the selection box
to the upper left. The buttons in the upper right enable creation of additional volume
groups and deletion of existing volume groups. Only volume groups that do not have
any partitions assigned can be deleted. All partitions that are assigned to a volume group
are also referred to as a physical volumes (PV).
Figure 7.3 Physical Volume Setup
To add a previously unassigned partition to the selected volume group, first click the
partition then Add Volume. At this point, the name of the volume group is entered next
to the selected partition. Assign all partitions reserved for LVM to a volume group.
Otherwise, the space on the partition remains unused. Before exiting the dialog, every
volume group must be assigned at least one physical volume. After assigning all phys-
ical volumes, click Next to proceed to the configuration of logical volumes.
Advanced Disk Setup 115