Upgrading An Existing Driver; Supported Upgrade Paths; What's New In Version 3.6.1; Upgrade Procedure - Novell IDENTITY MANAGER 3.6.1 - WORKORDER DRIVER IMPLEMENTATION GUIDE 18-12-2009 Implementation Manual

Upgrading an Existing Driver

5
If you are running the driver on the Metadirectory server, the driver shim files are updated when you
update the server unless they were not selected during a custom installation. If you are running the
driver on another server, the driver shim files are updated when you update the Remote Loader on
the server.
The 3.6.1 version of the driver shim supports drivers created by using any 3.x version of the driver
configuration file. You can continue to use these driver configurations until you want to upgrade
them.
The following sections provide information to help you upgrade an existing driver's configuration to
version 3.6.1:
Section 5.1, "Supported Upgrade Paths," on page 27
Section 5.2, "What's New in Version 3.6.1," on page 27
Section 5.3, "Upgrade Procedure," on page 27

5.1 Supported Upgrade Paths

You can upgrade from any 3.x version of the WorkOrder driver. Upgrading a pre-3.x version of the
driver directly to version 3.6.1 is not supported.

5.2 What's New in Version 3.6.1

The 3.6.1 version of the driver does not include any new features.

5.3 Upgrade Procedure

The process for upgrading the WorkOrder driver is the same as for other Identity Manager drivers.
For detailed instructions, see "Upgrading" in the Identity Manager 3.6.1 Installation Guide.
Upgrading an Existing Driver
5
27