Installing Driver Files; Chapter 3, "Installing Driver Files - Novell IDENTITY MANAGER 3.6.1 - WORKORDER DRIVER IMPLEMENTATION GUIDE 18-12-2009 Implementation Manual

Installing Driver Files

3
By default, the WorkOrder driver files are installed on the Metadirectory server at the same time as
the Metadirectory engine. The installation program extends the Identity Vault's schema and installs
both the driver shim and the driver configuration files. It does not create the driver in the Identity
Vault (see Chapter 4, "Creating a New Driver," on page
configuration (see Chapter 5, "Upgrading an Existing Driver," on page
If you performed a custom installation and did not not install the WorkOrder driver on the
Metadirectory server, you have two options:
Install the files on the Metadirectory server, using the instructions in
Metadirectory Server" in the
Install the Remote Loader (required to run the driver on a non-Metadirectory server) and the
driver files on a non-Metadirectory server where you want to run the driver. See
Remote Loader" in the
Identity Manager 3.6.1 Installation
Identity Manager 3.6.1 Installation
19) or upgrade an existing driver's
27).
"Installing the
Guide.
Guide.
3
"Installing the
Installing Driver Files 17