Table of Contents
Advertisement
PowerSoft
The status is indicated by means of both an ON/OFF text and a status LED
(respectively red/grey). If the inputs/output are not configured, they are shown in
this section as not available.
The digital output status can be manually modified by means of the "Enable"
and "Disable" buttons; the command is sent to the instrument after the positive
answer to a confirmation request. The digital output status can be changed only by
a user logged-in as "Administrator". Once the command has been sent, the new
status can be displayed only when the system polls the relevant instrument again.
NOTE: PowerSoft can manage only one digital output per instrument (the
first one, or the first of slot D, in case of a modular instrument). This output is to
be set as "REM" directly on the instrument.
3.4.4
F
This section shows the Fresnell diagram of the branch monitored by the
selected instrument. On the right, the details of each phase (voltage, current, phase
angle between them) are shown.
PowerSoft – Instruction manual
RESNELL
27
Advertisement
Table of Contents
