Table of Contents
Advertisement
PowerSoft
2.3
T
HE FIRST
The first time Powersoft is launched, an access code is required. The code
depends on the optional modules bought by the user.
To get the proper access code, the software supplier or distributor is to be
contacted, communicating him the access key provided by the software itself (in the
above example, see the picture, it is "HPKIFDCN"). Editing the returned access
code, paying attention to the capital letters, the software and the desired modules
are available.
Without the access code, PowerSoft cannot be used. The access code will
not expire and therefore it is not to be edited again.
IMPORTANT NOTE: the code is depending on the PC and on the hard-
disk. If the software is to be moved in another PC or in a new hard-disk, a new
access code is to be asked to the supplier.
PowerSoft – Instruction manual
P
OWERSOFT START
This window asks for the code after the first start-up
-
UP
13
Advertisement
Table of Contents
