Table of Contents
Advertisement
PowerSoft
3.4.1
A
The Indicators section is the default one when the real-time page is opened. It
shows the active and reactive system powers, the system power factor, the phase
currents, and the active and reactive energy meters (imported and exported). It is
not possible to change the displayed variables.
In the above picture, the red arrows show the setpoint values assigned to the
variables (system active power and current phase 1 in the example). Two setpoints
are available for each variable: an upper setpoint (red band, "up" type alarm) and
lower setpoint (yellow band, "down" type alarm). The minimum and maximum
values reached by the variable from the previous recording (variable data log on the
hard disk) are shown by means of two amber indicators, close to the scale.
PowerSoft – Instruction manual
NALOGUE INDICATORS
25
Advertisement
Table of Contents
