Pnp/Pci Configuration Setup - JETWAY 920BFR3A User Manual

• Stdby Speed (div by) : Select a divisor to reduce the CPU speed during Standby mode to a
fraction of the full CPU speed.
speed. The divisors range from 1 to 8-0.
The choice: 1~8
• Hot Key Function : Select Enabled your system has a hot key for pany Function.
The choice: Power off, Suspend, Disabled.
• PM Timers : The following four modes are Green PC power saving functions which are
only user configurable when User Defined Power Management has been selected. See
above for available selections.
• HDD Off After : By default, this item is Disabled, meaning that no matter the mode the
rest of the system, the hard drive will remain ready. Otherwise, you have a range of
choices from 1 to 15 minutes or Suspend. This means that you can elect to have your
hard disk drive be turned off after a selected number of minutes or when the rest of the
system goes into a Suspend mode.
• HDD Ports Activity : When set to On (default), any event occurring at a HDD (serial) port
will awaken a system which has been powered down.
• COM Ports Activity : When set to On (default), any event occurring at a hard or floppy
drive port will awaken a system which has been powered down.
• LPT Ports Activity : When set to On (default), any event occurring at a LPT (printer) port
will awaken a system which has been powered down.
• VGA Activity : When set to On (default), any event occurring at VGA will awaken a
system which has been powered down.
The following is a list of IRQ's, Interrupt ReQuests, which can be exempted much as the
COM ports and LPT ports above can. When an I/O device wants to gain the attention of
the operating system, it signals this by causing an IRQ to occur. When the operating
system is ready to respond to the request, it interrupts itself and performs the service.
As above, the choices are On and Off.
When set On, activity will neither prevent the system from going into a power management
mode nor awaken it.
• IRQ [ 3-7, 9-15], NMI
• IRQ 8 Break Suspend : You can Enable or Disable monitoring of IRQ8 (the Real Time
Clock) so it does not awaken the system from Suspend mode.
• KB Power ON Password : When you set a password for keyboard, The password you
set the keyboard that returns the system to Full On state.
• Power Button Over Ride : You could press the power button for more than 4 seconds
forces the system to enter the Soft-Off state when the system has "hung."
The choice: Soft-Off, Delay 4 Sec.
• Ring Power Up Control : When you select Enabled, a signal from ring returns the
system to Full On state.
• Power Up by Alarm : When you select Enabled, the following fields appear. They let you
set the alarm that returns the system to Full On state.
The choice: Enabled, Disabled.

3-5 PNP/PCI CONFIGURATION SETUP

This section describes configuring the PCI bus system.
Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the
CPU itself uses when communicating with its own special components. This section covers
some very technical items and it is strongly recommended that only experienced users should
make any changes to the default settings.
The speed is reduced to a fraction of the CPU's normal
24
PCI, or Personal Computer