Cpu Insertion - JETWAY 920BFR3A User Manual

FC-PGA with a PPGA heatsink

CPU Insertion

Heatsink Attachment
Step 1
Open the socket by raising the actuation lever.
Step 2
Insert the processor.
Ensure proper pin 1 orientation by aligning the
FC-PGA corner marking with the socket corner
closest to the actuation arm tip. The pin field is
keyed to prevent mis-oriented insertion.
Don't force processor into socket. If it does not go in
easily, check for mis-orientation and debris.
Make sure the processor is fully inserted into the
socket on all sides.
Step 3
Close the socket by lowering and locking the
actuation lever.
Step 1
Remove the protective liner from the thermal interface
material on the underside of the heatsink.
This liner is not normally present on the Intel reference
active heatsink.
Step 2
Orient the heatsink with the keyed edge of
heatsink along the cam box side of the
processor.
The clip should be oriented so that the thumb tab will
engage on the cam box side of the socket.
Step 3
Seat the heatsink onto the processor and engage
10
the clip opposite from the cam box onto its socket
tab first.
CAUTION: Do not slide the heatsink once it is
attached to the processor as the thermal interface