JETWAY 920BFR3A User Manual page 27

Resources Controlled By : Manual
Reset Configuration Data: Disabled
IR Q - 3 assigned to : PCI/ISA PnP
IR Q - 4 assigned to : PCI/ISA PnP
IR Q - 5 assigned to : PCI/ISA PnP
IR Q - 7 assigned to : PCI/ISA PnP
IR Q - 9 assigned to : PCI/ISA PnP
IR Q - 10 assigned to : PCI/ISA PnP
IR Q - 11 assigned to : PCI/ISA PnP
IR Q - 12 assigned to : PCI/ISA PnP
IR Q - 14 assigned to : Legacy ISA
IR Q - 15 assigned to : Legacy ISA
DMA-0 assigned to : PCI/ISA PnP
DMA-1 assigned to : PCI/ISA PnP
DMA-3 assigned to : PCI/ISA PnP
DMA-5 assigned to : PCI/ISA PnP
DMA-6 assigned to : PCI/ISA PnP
DMA-7 assigned to : PCI/ISA PnP
• Resource controlled by :
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot
and Plug and Play compatible devices. However, this capability means absolutely nothing
unless you are using a Plug and Play operating system such as Windows
The choice: Auto, Manual.
• Reset Configuration Data:
Normally, you leave this field Disabled.
Configuration Data (ESCD) when you exit Setup if you have installed a new add-on and
the system reconfiguration has caused such a serious conflict that the operating system
can not boot.
The choice: Enabled, Disabled .
• IRQ3/4/5/7/9/10/11/12/14/15:
When resources are controlled manually, assign each system interrupt as one of the
following types, depending on the type of device using the interrupt:
Legacy ISA Devices compliant with the original PC AT bus specification, requiring a
specific interrupt ( such as IRQ4 for serial port 1). PCI/ISA PnP Devices compliant with
the Plug and Play standard, whether designed for PCI or ISA bus architecture.
The choice: Legacy ISA, PCI/ISA PnP.
• DMA0/1/3/5/6/7 assigned to:
When resources are controlled manually, assign each system DMA channel as one of the
following types, depending on the type of device using the interrupt:
Legacy ISA Devices compliant with the original PC AT bus specification, requiring a
specific interrupt ( such as IRQ4 for serial port 1). PCI/ISA PnP Devices compliant with
the Plug and Play standard, whether designed for PCI or ISA bus architecture.
The choice: Legacy ISA, PCI/ISA PnP.
3-6 LOAD BIOS DEFAULTS
The "LOAD BIOS DEFAULTS" function loads the system default data directly from ROM and
initialize associated hardware properly. This function will be necessary only when the system
CMOS data is corrupted.
ROM PCI/ISA BIOS (2A6INJ19)
PNP/PCI CONFIGURATION SETUP
AWARD SOFTWARE, INC.
Esc: Q u it
F1 : Help
F5 : Old Values (Shift)F2 : Color
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
Figure 3-6
Select Enabled to reset Extended System
25
¡ ô ¡ õ ¡ ÷ ¡ ö : Select Item
Pu/Pd/ + / -:Modify

95.