Table of Contents
Advertisement
chrono graphs wiTh BIG date anD day
Measuring accumulated time
. Start: press push-button a. The center sweep hand will begin measuring
seconds.
. Stop: press push-button a. read the 3 chronograph counters.
. Resume timing: press push-button a again.
. Stop: press push-button a. read the 3 chronograph counters.
. Repeat this process as many times as needed.
. Reset: press push-button B. The chronograph hands will be reset to their
zero positions.
0
chrono graphs wiTh BIG date anD day
. Start: press push-button a. The center sweep hand will begin measuring
seconds.
. Stop: press push-button B. This will indicate intermediate time.
. Start again: press push-button B again.The hands will turn at a much
faster speed until they measure the time elapsed since the chronograph
was first started. They will then continue to move at a normal speed.
. A further intermediate time can be measured by repeating this
procedure.
. Stop: press push-button a and read the 3 chronograph counters.
. Reset: press push-button B. The chronograph hands will be reset to
their zero positions.
Measuring Intermediate time
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the INVICTA and is the answer not in the manual?
Questions and answers
How do I adjust the watch band on the coalition forces Vulcan X
To adjust the watch band on the Invicta Coalition Forces Vulcan X, follow these steps:
1. Identify the direction of the arrows on the bracelet, which indicate the direction to push the pins.
2. Use the quick release band adjustment tool to push the pins in the direction of the arrows.
3. Once the pin is partially released, remove it completely with your fingers.
4. If needed, repeat the process to remove additional links.
5. To reassemble, insert the pin back in the opposite direction it was removed.
6. Use a mallet to gently tap the pin into place.
This method allows you to resize the watch band easily.
This answer is automatically generated