Table of Contents
Advertisement
chrono graphs
Setting the time
. Pull out the crown to position .
To set the time to the exact second, it must be pulled out when seconds
hand is in position 0. The watch stops.
. Turn the crown until you reach the correct time.
. Push the crown back into position 0.
To set the time to the exact second, it must be pushed back into position
0 at the exact second.
0
. Pull out the crown to position .
The watch continues to run.
. Turn the crown until you reach the correct date.
. Push the crown back into position 0.
To set the time to the exact second, it must be pushed back into
position 0 at the exact second.
! PLeASe NoTe . if you are setting the date between 9pm and 12pm, the
date must be set to the following day.
chrono graphs
Setting the date . Quick Mode
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the INVICTA and is the answer not in the manual?
Questions and answers
How do I adjust the watch band on the coalition forces Vulcan X
To adjust the watch band on the Invicta Coalition Forces Vulcan X, follow these steps:
1. Identify the direction of the arrows on the bracelet, which indicate the direction to push the pins.
2. Use the quick release band adjustment tool to push the pins in the direction of the arrows.
3. Once the pin is partially released, remove it completely with your fingers.
4. If needed, repeat the process to remove additional links.
5. To reassemble, insert the pin back in the opposite direction it was removed.
6. Use a mallet to gently tap the pin into place.
This method allows you to resize the watch band easily.
This answer is automatically generated