Moxa Technologies UPort 1200 Series Quick Installation Manual
Usb-to-serial converter
Hide thumbs
Also See for UPort 1200 Series:
- User manual (36 pages) ,
- Quick installation manual (7 pages) ,
- Quick installation manual (6 pages)
Related Manuals for Moxa Technologies UPort 1200 Series
Summary of Contents for Moxa Technologies UPort 1200 Series
- Page 1 UPort 1200/1400/1600 Series Quick Installation Guide USB-to-Serial Converter Version 9.6, July 2024 Technical Support Contact Information www.moxa.com/support 2024 Moxa Inc. All rights reserved. P/N: 180201400001E *180201400001E*...
- Page 2 WARNING 1. This unit is not intended for consumer use. It will only be shipped to manufacturers or factories. 2. The DC source should come from a class external adapter or a 12 to 48 VDC safety extra-low voltage (SELV) limited power source (LPS), using a transfer device.
-
Page 3: Ordering Information
Ordering Information Package Checklist Before installing the UPort, verify that the package contains the following items: • 1 UPort 1200/1400/1600 USB-to-serial converter • USB cable: CBL-USBA/B-100 • 100 to 240 VAC power adapter (excluding the UPort 1250/1410) 1 power cord suitable for your region (UPort 1600-16 models •... - Page 4 Refer to the table below to see whether external power is needed for your UPort. If applicable, connect the UPort to an external power source. UPort UPort UPort UPort UPort 1250 1250I 1400 1600-8 1600-16 Bus Power – – – ...
- Page 5 Installing the UPort 1200/1400/1600 Driver 1. Connect the UPort to the PC using the USB cable. 2. After turning your PC’s power on, Windows will automatically detect the UPort. 3. Run the Setup program that you may find on Moxa’s support website http://www.moxa.com/support/.
- Page 6 6. Click Install to proceed with the installation. 7. The installation will take a few minutes to complete. 8. After the driver has been installed successfully, you can click Scan to review the installation results if the UPort is connected to your computer.
- Page 7 9. Check Launch Windows Driver Manager after finish to configure the UPort after quitting the driver installer. Installing the macOS Driver For macOS 10.12 and later, follow the steps below to install the driver: 1. Enter recovery mode. 2. Disable System Integrity Protection (SIP) by typing 'csrutil disable' in the terminal.
-
Page 8: Serial Port Pin Assignments
Serial Port Pin Assignments The serial ports on the UPort 1200/1400/1600 have DB9 male connectors. Refer to the following table below for the RS-232 and RS- 422/485 pin assignments. NOTE For UPort with DB Male Serial Ports, you may refer to DB9 Male Ports pin assignment section to loop back pin 2 and pin 3 for the RS-232 interface to carry out a self-test on the device. - Page 9 UPort 1400/1600 There are five LEDs per port for indicating the status of the ports. The LEDs are listed under P1, P2, P3, etc. LED Name LED Color LED Function Active Power is on; when the firmware is ready, the LED will turn green If the device’s LED remains red, it means the firmware is not ready, and the device cannot...
- Page 10 UPort 1400 DIP Switches UPort 1600-8 DIP Switches UPort 1600-16 DIP Switches - 10 -...
Need help?
Do you have a question about the UPort 1200 Series and is the answer not in the manual?
Questions and answers