Red Hat ENTERPRISE LINUX 4.5.0 Reference Manual page 70

Chapter 4. The sysconfig Dire...
•
VNCSERVERS=<value>
VNC server should be started for user fred on display :1. User fred must have set a VNC
password using the
server.
Note that when using a VNC server, communication with it is unencrypted and it should not be
used on an untrusted network. For specific instructions concerning the use of SSH to secure
VNC communication, read the information found online at
http://www.uk.research.att.com/archive/vnc/sshvnc.html. To find out more about SSH, refer to
Chapter 20, SSH Protocol
1.40.
/etc/sysconfig/xinetd
The
/etc/sysconfig/xinetd
time. The daemon starts programs that provide Internet services when a request to the
xinetd
port for that service is received. For more information about available parameters for this file,
refer to the man page. For more information on the
xinetd
" ".
xinetd
2. Directories in the
The following directories are normally found in
• — This directory contains the APM suspend/resume script. Do not edit the
apm-scripts/
files directly. If customization is necessary, create a file called
/etc/sysconfig/apm-scripts/apmcontinue
also possible to control the script by editing
• — This directory contains the configuration files needed to do Class Based Queuing for
cbq/
bandwidth management on network interfaces. CBQ divides user traffic into a hierarchy of
classes based on any combination of IP addresses, protocols, and application types.
• — This directory is used by the Network Administration Tool
networking/
(
system-config-network
information about configuring network interfaces using the Network Administration Tool,
refer to the chapter called Network Configuration in the Red Hat Enterprise Linux System
Administration Guide.
•
network-scripts/
files:
• Network configuration files for each configured network interface, such as
the Ethernet interface.
eth0
• Scripts used to bring up and down network interfaces, such as
• Scripts used to bring up and down ISDN interfaces, such as
46
, where is set to something like
<value>
command before attempting to connect to the remote VNC
vncpasswd
in the Red Hat Enterprise Linux System Administration Guide.
file is used to pass arguments to the
/etc/sysconfig/
), and its contents should not be edited manually. For more
— This directory contains the following network-related configuration
"1:fred"
xinetd
service, refer to
xinetd
Directory
.
/etc/sysconfig/
which is called at the end of the script. It is
/etc/sysconfig/apmd
ifup
ifup-isdn
, to indicate that a
daemon at boot
Section 3,
.
ifcfg-eth0
and .
ifdown
and
ifdown-isdn
for
.