Red Hat ENTERPRISE LINUX 4.5.0 Reference Manual page 314

Chapter 15. FTP
• — Specifies the amount of time for a client using passive mode to establish
accept_timeout
a connection.
The default value is
• — Specifies the maximum data transfer rate for anonymous users in bytes
anon_max_rate
per second.
The default value is
•
connect_from_port_20
on the server during active mode data transfers. Disabling this option allows
with less privileges, but may be incompatible with some FTP clients.
The default value is
• — Specifies the maximum amount of time a client using active mode has
connect_timeout
to respond to a data connection, in seconds.
The default value is
•
data_connection_timeout
to stall, in seconds. Once triggered, the connection to the remote client is closed.
The default value is
• — Specifies the port used for active data connections when
ftp_data_port
connect_from_port_20
The default value is
•
idle_session_timeout
a remote client. Once triggered, the connection to the remote client is closed.
The default value is
• — Specifies the IP address on which
listen_address
connections.
There is no default value for this directive.
Tip
If running multiple copies of
configuration file for each copy of the
value for this directive. Refer to
for more information about multihomed FTP servers.
• — Specifies the IPv6 address on which
listen_address6
290
.
60
, which does not limit the transfer rate.
0
When enabled,
vsftpd
. Note, in Red Hat Enterprise Linux, the value is set to
NO
.
60
— Specifies maximum amount of time data transfers are allowed
.
300
is set to .
YES
.
20
— Specifies the maximum amount of time between commands from
.
300
vsftpd
runs with enough privileges to open port 20
listens for network
vsftpd
serving different IP addresses, the
daemon must have a different
vsftpd
Section 4.1, "Starting Multiple Copies of
vsftpd
to run
vsftpd
.
YES
vsftpd
listens for network
"