Ipsec Interfaces - Red Hat ENTERPRISE LINUX 4.5.0 Reference Manual

Chapter 8. Network Interfaces
in conjunction with
HWADDR
•
MASTER=<bond-interface>
which the interface the Ethernet interface is linked.
This directive is used in conjunction with the
Refer to Section 2.3, "Channel Bonding Interfaces"
interfaces.
• , where
NETMASK=<mask>
•
NETWORK=<address>
as the value is calculated automatically with
• , where
ONBOOT=<answer>
• — This device should be activated at boot-time.
yes
• — This device should not be activated at boot-time.
no
• , where
PEERDNS=<answer>
• — Modify
yes /etc/resolv.conf
default.
• — Do not modify
no
•
SLAVE=<bond-interface>
• — This device is controlled by the channel bonding interface specified in the
yes
directive.
• — This device is not controlled by the channel bonding interface specified in the
no
directive.
This directive is used in conjunction with the
Refer to Section 2.3, "Channel Bonding Interfaces"
•
SRCADDR=<address>
packets.
• , where
USERCTL=<answer>
• — Non-root users are allowed to control this device.
yes
• — Non-root users are not allowed to control this device.
no

2.2. IPsec Interfaces

With Red Hat Enterprise Linux it is possible to connect to other hosts or networks using a
122
.
,where
<bond-interface>
is the netmask value.
<mask>
, where is the network address. This directive is deprecated,
<address>
is one of the following:
<answer>
is one of the following:
<answer>
if the DNS directive is set. If using DHCP, then
.
/etc/resolv.conf
,where
<bond-interface>
, where is the specified source IP address for outgoing
<address>
is one of the following:
<answer>
is the channel bonding interface to
directive.
SLAVE
for more about channel bonding
.
ifcalc
is one of the following:
directive.
MASTER
for more about channel bond interfaces.
is the
yes
MASTER
MASTER