Removing A Failover Domain - Red Hat ENTERPRISE LINUX 5 - ADMINISTRATION Manual

Chapter 5. Configuring Red Hat Cluster With system-config-cluster
Figure 5.8. Failover Domain Configuration: Adjusting Priority
b. For each node that requires a priority adjustment, click the node listed in the Member Node/
Priority columns and adjust priority by clicking one of the Adjust Priority arrows. Priority is
indicated by the position in the Member Node column and the value in the Priority column.
The node priorities are listed highest to lowest, with the highest priority node at the top of the
Member Node column (having the lowest Priority number).
7. Click Close to create the domain.
8. At the Cluster Configuration Tool, perform one of the following actions depending on whether
the configuration is for a new cluster or for one that is operational and running:
• New cluster — If this is a new cluster, choose File => Save to save the changes to the cluster
configuration.
• Running cluster — If this cluster is operational and running, and you want to propagate the
change immediately, click the Send to Cluster button. Clicking Send to Cluster automatically
saves the configuration change. If you do not want to propagate the change immediately,
choose File => Save to save the changes to the cluster configuration.

5.6.2. Removing a Failover Domain

To remove a failover domain, follow these steps:
1. At the left frame of the Cluster Configuration Tool, click the failover domain that you want to
delete (listed under Failover Domains).
62