Red Hat ENTERPRISE LINUX 3 Reference Manual page 57

Hide thumbs Also See for ENTERPRISE LINUX 3:
Table of Contents

Advertisement

sysconfig
Chapter 4. The
For more information about what parameters are available for this file, refer to the
For detailed information on how to configure a BIND DNS server, refer to Chapter 12 Berkeley Inter-
net Name Domain (BIND). By default, the file contains no parameters.
4.1.21.
/etc/sysconfig/netdump
The
/etc/sysconfig/netdump
vice. The
service sends both oops data and memory dumps over the network. In general,
netdump
is not a required service; only run it if absolutely necessary. For more information about
netdump
what parameters are available for this file, refer to the
4.1.22.
/etc/sysconfig/network
The
/etc/sysconfig/network
figuration. The following values may be used:
NETWORKING= value
— Networking should be configured.
yes
— Networking should not be configured.
no
HOSTNAME= value
such as
hostname.expample.com
Note
For compatibility with older software that people might install (such as
file should contain the same value as here.
GATEWAY= value
GATEWAYDEV= value
NISDOMAIN= value
4.1.23.
/etc/sysconfig/ntpd
The
/etc/sysconfig/ntpd
The
daemon sets and maintains the system clock to synchronize with an Internet standard
ntpd
time server. It implements version 4 of the Network Time Protocol (NTP). For more information
about what parameters are available for this file, point a Web browser at the following file:
/usr/share/doc/ntp- version /ntpd.htm
). By default, this file sets the owner of the
ntpd
4.1.24.
/etc/sysconfig/pcmcia
The
/etc/sysconfig/pcmcia
lowing values may be used:
PCMCIA= value
Directory
file is the configuration file for the
file is used to specify information about the desired network con-
, where
value
, where
value
, but can be whatever hostname is necessary.
, where
is the IP address of the network's gateway.
value
, where
value
, where
value
file is used to pass arguments to the
file is used to specify PCMCIA configuration information. The fol-
, where
is one of the following:
value
man page.
netdump
is one of the following boolean values:
should be the Fully Qualified Domain Name (FQDN),
is the gateway device, such as
is the NIS domain name.
(where
version
process to the user
ntpd
man page.
named
/etc/init.d/netdump
), the
trn
/etc/HOSTNAME
.
eth0
daemon at boot time.
ntpd
is the version number of
.
ntp
39
ser-

Advertisement

Table of Contents
loading

Table of Contents