Red Hat ENTERPRISE LINUX 3 Reference Manual page 241

Chapter 14. FTP
The default value is
• listen_address
There is no default value for this directive.
Tip
If running multiple copies of
copy of the
vsftpd
Starting Multiple Copies of
• listen_address6
tions when
listen_ipv6
There is no default value for this directive.
Tip
If running multiple copies of
copy of the
vsftpd
Starting Multiple Copies of
— Specifies the port on which
• listen_port
The default value is
• local_max_rate
server in bytes per second.
The default value is
— Specifies the maximum number of simultaneous clients allowed to connect to
•
max_clients
the server when it is running in standalone mode. Any additional client connections results in an
error message.
The default value is
— Specifies the maximum of clients allowed to connected from the same source IP
• max_per_ip
address.
The default value is
— Specifies the IP address for the public facing IP address of the server for servers
•
pasv_address
behind Network Address Translation (NAT) firewalls. This enables
return address for passive mode connections.
There is no default value for this directive.
— When enabled, passive mode connects are allowed.
• pasv_enable
The default value is
• pasv_max_port
connections. This setting is used to limit the port range so that firewall rules are easier to create.
The default value is
exceed .
65535
• pasv_min_port
connections. This setting is used to limit the port range so that firewall rules are easier to create.
The default value is
lower .
1024
.
300
— Specifies the IP address on which
vsftpd
daemon must have a different value for this directive. Refer to Section 14.4.1
for more information about multihomed FTP servers.
vsftpd
— Specifies the IPv6 address on which
is set to
YES
vsftpd
daemon must have a different value for this directive. Refer to Section 14.4.1
for more information about multihomed FTP servers.
vsftpd
.
21
— Specifies the maximum rate data is transfered for local users logged into the
, which does not limit the transfer rate.
0
, which does not limit connections.
0
, which does not limit connections.
0
.
YES
— Specifies the highest possible port sent to the FTP clients for passive mode
, which does not limit the highest passive port range. The value must not
0
— Specifies the lowest possible port sent to the FTP clients for passive mode
, which does not limit the lowest passive port range. The value must not be
0
vsftpd
serving different IP addresses, the configuration file for each
.
serving different IP addresses, the configuration file for each
listens for network connections.
vsftpd
listens for network connections.
listens for network connec-
vsftpd
to hand out the correct
vsftpd
223