Red Hat ENTERPRISE LINUX 3 Reference Manual page 240

222
— Specifies the
• xferlog_file
xferlog_enable
used if
dual_log_enable
The default value is
• xferlog_std_format
a -compatible file transfer log is written to the file specified in the
wu-ftpd
directive (
/var/log/xferlog
transfers and does not log connections to the server.
The default value is
Important
To maintain compatibility with log files written by the older
xferlog_std_format
means that connections to the server are not logged.
To both log connections in
dual_log_enable
If maintaining a
wu-ftpd
to , comment the line with a hash mark (
NO
14.5.8. Network Options
The following is a list of directives which affect how
• accept_timeout
connection.
The default value is
• anon_max_rate
second.
The default value is
• connect_from_port_20
the server during active mode data transfers. Disabling this option allows
privileges, but may be incompatible with some FTP clients.
The default value is
• connect_timeout
respond to a data connection, in seconds.
The default value is
•
data_connection_timeout
stall, in seconds. Once triggered, the connection to the remote client is closed.
The default value is
• ftp_data_port
connect_from_port_20
The default value is
• idle_session_timeout
remote client. Once triggered, the connection to the remote client is closed.
wu-ftpd
must be enabled and
is set to
YES
/var/log/xferlog
— When enabled in conjunction with
by default). It is important to note that this file only logs file
, however under Red Hat Enterprise Linux the value is set to
NO
directive is set to
format and maintain a
vsftpd
to .
YES
-compatible file transfer log is not important, either set
— Specifies the amount of time for a client using passive mode to establish a
.
60
— Specifies the maximum data transfer rate for anonymous users in bytes per
, which does not limit the transfer rate.
0
When enabled,
, however under Red Hat Enterprise Linux the value is set to
NO
— Specifies the maximum amount of time a client using active mode has to
.
60
— Specifies maximum amount of time data transfers are allowed to
.
300
— Specifies the
is set to
YES
.
20
— Specifies the maximum amount of time between commands from a
-compatible log file. For this file to be used,
xferlog_std_format
.
.
under Red Hat Enterprise Linux. However, this setting
YES
wu-ftpd
), or delete the line entirely.
#
interacts with the network.
vsftpd
runs with enough privileges to open port 20 on
vsftpd
port used for
.
Chapter 14. FTP
must be set to
xferlog_enable
xferlog_file
FTP server, the
wu-ftpd
-compatible file transfer log, set
xferlog_std_format
to run with less
vsftpd
active data connections
. It is also
YES
, only
.
YES
.
YES
when