Table of Contents
Advertisement
Text Engraving
The engraving information and options are as follow:
Text Engraving
Number
Name
Menu Action
Text
Symbols
Font Selection A drop down list of fonts supported by KeypadBuilder for use in engraving the buttons. Icons
Scale
Note: If your font selection or scale is greater than the area of the button that can be engraved, you will
receive a warning in this field and KeypadBuilder will not create the .DXF file.
Update
Display Options
These display options are for use within the Engraving window. Placing a check in any box activates its
display.
Display Options
Show Button Numbers
Show Button Names
Show Menu Actions
Show Channel Codes
Show Bounding Box
Export to DXF File
KeypadBuilder creates the .DXF file that is applied to a jig in the engraving machine.
Export to DXF File
Export File...
Preview...
Click OK to keep changes and exit the Engraving module; otherwise, click Cancel and lose the changes.
KeypadBuilder v2.1
This number is dictated by the selected device's firmware and is intended to assist in
navigating the keypad device file.
The button name is for use within KeypadBuilder only and is intended to assist in developing
unique names. The name is established in the Button Configuration module.
If a menu action is assigned in the Button Configuration module, the action is displayed in this
field; otherwise, it is blank.
This is either the text or icon set to display on the button. The text is dictated by the font
selection. If you select Icon in the font selection, you could use letters to get the associated
icon but the Symbols drop down list is a simpler approach. There is a limit of 10 characters per
button.
The Symbols drop down list is available when you select AMX Icon in the font selection list.
The list is a collection of icons created by AMX. When you select an icon the corresponding
letter is placed in the Text field. If you select more than one icon it will not replace the previous
icon, but rather add it and display all selected icons.
must be selected to use the Symbols drop down list.
A ratio ranging from 0.5 to 1.5. The larger the ratio, the more area of the button the text or icon
fills.
Confirms changes to the button engraving.
Displays all button numbers.
Displays the button name if set.
Displays the menu action value for the button.
Displays set channel codes for the keypad device.
Displays the surface area of the button you can engrave.
Opens the Export DXF File dialog window. This creates the .DXF file
necessary for engraving.
Opens the Engraving Template Preview dialog window. This is a graphic
representation of the jig used in engraving.
Mio Attaché Configuration Modules
59
Advertisement
Table of Contents
