Related Manuals for ETEKCITY LASERGRIP 630
Summary of Contents for ETEKCITY LASERGRIP 630
- Page 1 +ETEKCIT LASERGRIP Infrared Thermometer User Manual Questions or Concerns? Please contact us Mon-Fri 9:00 - 6:00 PM PST at (855) 686-3835 or email support@etekcity.com THIS PRODUCT COMPLIES WITH 21 CFR 1040.10 1040.11.
- Page 2 Should you have any questions or concerns, feel free to contact our helpful customer support team toll-free at 855.686.3835 or by email at support@etekcity.com. CAUTION AVOID EXPOSURE LASER RADIATION LASER RADIATION STARE INTO BEAM IS EMITTED FROM THIS APERATURE.
-
Page 3: Features And Specifications
Do not use the Lasergrip as a reliable source to measure body temperatures. Package Contents 1 x Etekcity Lasergrip 630 Infrared Thermometer I x 9V DC Battery 1 x User Manual Features & Specifications... -
Page 4: Function Diagram
Function Diagram LCD Display Display Backlight / Laser Pointers/ (HOLD) Unit (OC/OF) Mode Selection UP / DOWN Battery Compartment Measurement Trigger Laser Hole IR Sensor Display Icon Key HOLD Hold temperature results Laser guidance activated L//_/L/8 Low battery power Current / Last temperature reading 888.8 Secondary... - Page 5 5. The area between each laser point is the area of measurement. Once the lasers are pointed to the desired area of measurement, release the trigger and the LCD display will lock the calculated temperature. 6. Press the measurement trigger once again to make another measurement.
- Page 6 Measurement Modes Press the mode button repeatedly to cycle through and select from the following measurement modes: Function Mode Displays the maximum recorded temperature last measurement. Displays the minimum recorded temperature last measurement. Displays the average temperature for the last measurement.
- Page 7 PAIR Polarity facing upward 9V Battery Distance-Spot Ratio The Lasergrip 630 measures surface temperature on the basis of distance to spot diameter ratio (D:S). As the distance between the thermometer and the surface increases, the total surface area measured will also increase.
- Page 8 (2) this device must accept any interference received. Including interference that may cause undesired operation. device certification information ETEKCITY labeled directly on the device. The LASERGRIP sticker is located on the left side of the INFRARED THERMOMETER...
- Page 9 EmissivityOf Materials Type Type Material Emissivity Emissivity Material Oxidized Human skin o. 98 Aluminium o. 02- Graphite o. 20- o. 60 Polished Oxidized non- Oxidized Plastic o. 95 transparent Brass Polished Rubber o. 95 Gold o. 01-0. Plastic cement o. 85-0. Iron Oxidized Concrete...
- Page 10 METEKCITY a simpler life starts here. Questions or Concerns? Please contact us Mon-Fri 9:00 - 6:00 at (855) 686-3835 or email support@etekcity.com visit www.etekcity.com for more products.
Need help?
Do you have a question about the LASERGRIP 630 and is the answer not in the manual?
Questions and answers