Advertisement
3300 Installation Instructions
INSTALLATION OF LRM-5
Before using, attach the suction cup and rubber bumpers (2) to
the metal bracket. If necessary, you may bend the metal bracket
in order to position the LRM-5 correctly (3-lens array facing
forward, single lens facing behind.)
LRM-5 mounted with windshield bracket.
Using Hook & Loop Fasteners, the LRM-5 may also be mounted
to the back side of your rearview mirror. Be careful not to block
the rear facing lens when mounted in this manner. Also, clean
the appropriate surfaces with isopropyl alcohol before adhering
the adhesive side of the fastener to those surfaces.
LRM-5 mounted to rearview mirror with Hook & Loop Fasteners.
10/4/00
9:37 AM
Page 15
12
INSTALLATION OF CONTROL PANEL
General Information
The control panel may be mounted using the Under Dash
Bracket or Hook & Loop fastener supplied. As an alternative, you
may also use a Through Dash Bracket. When choosing a mounting
location, consider your needs for ease of viewing the display,
accessibility of controls (remember Mute Mode may be used
frequently), and concealment.
Control Panel Mounted With Under Dash Bracket
Fasten the Under Dash Bracket to your vehicle's dash with the
two #4 x 5/8" sheet metal screws provided. A 5/64" drill bit
should be used to drill pilot holes for the screws. Use the holes in
the bracket to mark the location for pilot holes.
Once the bracket is fastened to your vehicle, the control panel
can be attached to it. However, we suggest connecting all cables
to the back of the control panel before snapping it into the bracket.
See page 15 for proper placement of cables.
HIGHWAY
Control panel snaps into rather than slides onto the Under Dash
Bracket.
13
HIGHWAY
Advertisement
