Advertisement
Pro3450INSTALLmanual.pdf
3/15/04
I N S T A L L A TION OF LASERA N T E N N A
Installing the Laser Antenna
Before using, attach the suction cup and rubber bumpers (2)
to the metal bracket. If necessary, you may bend the metal
b r a c k e t in order to position the laser antenna correctly (3-lens
a rray facing f o rw a rd, single lens facing behind.)
Laser antenna mounted with windshield bracket.
Using Hook & Loop Fasteners, the laser antenna may also be
mounted to the back side of your rearview mirror. Be careful not
to block the rear facing lens when mounted in this manner.
Also, clean the appropriate surfaces with isopropyl alcohol before
a d h e ring the adhesive side of the fastener to those surfaces.
Laser antenna mounted to rearview mirror with Hook & Loop Fasteners.
3:18 PM
Page 15
13
I N S T A L L A TION OF CONTROL PA N E L
General Information
The control panel may be mounted using the Under Dash
Bracket or Hook & Loop fastener supplied. As an alternative, you
may also use a Through Dash Bracket. When choosing a mounting
location, consider your needs for ease of viewing the display,
accessibility of controls (remember Mute Mode may be used
frequently), and concealment.
The Pro-3450 can also be mounted on its side and even upside
down! Installation just got a lot easier.
Control Panel Mounted With Under Dash Bracket
Fasten the Under Dash Bracket to your vehicle's dash with the
two #4 x 5/8" sheet metal screws provided. A 5/64" drill bit
should be used to drill pilot holes for the screws. Use the holes in
the bracket to mark the location for pilot holes.
Once the bracket is fastened to your vehicle, the control panel
can be attached to it. However, we suggest connecting all cables
to the back of the control panel before snapping it into the bracket.
See page 15 for proper placement of cables.
HIGHWAY
Control panel snaps into rather than slides onto the Under Dash Bracket.
14
HIGHWAY
Advertisement
