Advertisement
INST ALLA TION OF LASERANTENNA
Installing the Laser Antenna
Before using, attach the suction cup and rubber bumpers (2)
to the metal bracket. If necessary, you may bend the metal
bracket in order to position the laser antenna correctly (3-lens
array facing forward, single lens facing behind.)
Laser antenna mounted with windshield bracket.
Using Hook & Loop Fasteners, the laser antenna may also be
mounted to the back side of your rearview mirror. Be careful not
to block the rear facing lens when mounted in this manner.
Also, clean the appropriate surfaces with isopropyl alcohol before
adhering the adhesive side of the fastener to those surfaces.
Laser antenna mounted to rearview mirror with Hook & Loop Fasteners.
13
INST ALLA TION OF CONTROLPANEL
The Fuzion remote is designed to fit into standard 2 1/16"
gauge housings. This unit is perfect to complement other
gauges in a pillar pod or install in its own gauge housing.
Since the control panel dimensions are the same as standard
automotive gauges, the aftermarket offers many enclosures
that can customize the installation
Depending on the housing, the Fuzion control panel may
either be tight or loose fitting. If loose, we provide a special
"U" shaped bracket that will hold the control panel tightly to
the housing. This same bracket can be used when flush
mounting the control panel to a location in the vehicle's dash
or installation in an under dash kit.
The "U" bracket is held in place using the supplied 5mm nuts
and washers. DO NOT remove the nuts already installed on
the control panel.
If the unit is installed into a pillar housing, see the pillar
housing instructions (if any) for proper installation for that
housing.
14
Advertisement
