3300 Installation Instructions 10/4/00 9:37 AM Page 3 TABLE OF CONTENTS Tools Required for Installation Topic Page •Phillips or Blade Screw Driver •3/8" Open End Wrench •Electric Drill Whistler 3300 Components •Drill Bits: 3/16", 5/64", 7/64", 9/64", and 13/64" •Other Tools May Be Required Based On Your Vehicle Type...
3300 Installation Instructions 10/4/00 9:37 AM Page 5 WHISTLER 3300 COMPONENTS MOUNTING BRACKETS Antenna Mounting Brackets And 45º Reflector Radar Antenna Large L Bracket (1) Temperature Probe Small L Brackets (2) The waterproof radar antenna with Temperature Probe is mounted at the front of your vehicle, usually behind the grill.
3300 Installation Instructions 10/4/00 9:37 AM Page 7 MOUNTING FASTENERS MOUNTING FASTENERS Reference Description/Use Qty. Bolt #10-32 x 1-1/4" • Fastens Large L or Small L Bracket to vehicle support. Bolt Bolt Bolt #10-32 x 1/2" #10-32 x 1/2" • Fastens Small L to Large L #10-32 x 1-1/4"...
3300 Installation Instructions 10/4/00 9:37 AM Page 9 INSTALLATION OF RADAR ANTENNA INSTALLATION OF RADAR ANTENNA General Information The radar antenna is waterproof and designed to be mounted at the front of your vehicle. In most vehicles the best mounting location is directly behind the grille;...
Page 6
3300 Installation Instructions 10/4/00 9:37 AM Page 11 INSTALLATION OF RADAR ANTENNA INSTALLATION OF RADAR ANTENNA Best mounting angle for optimum detection of all types of radar guns. Large L and Small L Brackets may be used in combination. The Small L Brackets are fastened to the Large L Bracket using the #10-32 x 1/2"...
3300 Installation Instructions 10/4/00 9:37 AM Page 13 INSTALLATION OF RADAR ANTENNA INSTALLATION OF LRM-5 Mount the antenna to the vehicle such that the ANTENNA window Antenna Cable To Control Panel is facing the road surface, sky, right or left of the vehicle, and the Once the antenna is installed, run the cable along the edge of the reflector has an unobstructed view of the road ahead.
3300 Installation Instructions 10/4/00 9:37 AM Page 15 INSTALLATION OF LRM-5 INSTALLATION OF CONTROL PANEL Before using, attach the suction cup and rubber bumpers (2) to General Information the metal bracket. If necessary, you may bend the metal bracket The control panel may be mounted using the Under Dash in order to position the LRM-5 correctly (3-lens array facing Bracket or Hook &...
Page 9
3300 Installation Instructions 10/4/00 9:37 AM Page 17 INSTALLATION OF CONTROL PANEL INSTALLATION OF CONTROL PANEL Antenna Cable Connection Control Panel Mounted With Hook & Loop Fasteners The stereo connector (straight end) on the end of the antenna Fasteners can be used to mount the top or bottom of the control cable plugs into Radar 1 port (2) on the back of the control panel.
NOTE: This is the only audio option that can be plugged into panel and front antenna (RADAR 1). the Whistler 3300. Any other device may damage the unit and •Check antenna connection at back of control panel. void the warranty.
Page 11
•R2 was shut off by a factory reset. See Reset Features section of owner’s manual. If difficulties occur which cannot be solved by information in this Troubleshooting Guide, please call Whistler Consumer Relations at 1-800-531-0004 before returning your unit for service, or contact us via email: info@whistlergroup.com.
Need help?
Do you have a question about the 3300 and is the answer not in the manual?
Questions and answers