Advertisement
3300 Installation Instructions
TROUBLESHOOTING GUIDE
PROBLEM: Display shows R2.
•Warning communicates "loss of link" between control
panel and rear antenna (RADAR 2); occurs only if rear
antenna has been installed.
•Check antenna connection at back of control panel.
•If no rear antenna is installed, perform the factory reset
procedure outlined in the owner's manual.
•Contact factory is you suspect rear antenna is defective.
PROBLEM: Display shows R2 ON?
•Rear antenna connected to RADAR 2 port. Press DARK
for yes or CITY for no.
•R2 was shut off by a factory reset. See Reset Features
section of owner's manual.
If difficulties occur which cannot be solved by information in this
Troubleshooting Guide, please call Whistler Consumer
Relations at 1-800-531-0004 before returning your unit for service,
or contact us via email: info@whistlergroup.com.
10/4/00
9:37 AM
Page 21
Also see Pg. 18-19 of Owner's Manual.
18
NOTES
Advertisement
