Advertisement
3300 Installation Instructions
INSTALLATION OF CONTROL PANEL
Control Panel Mounted With Hook & Loop Fasteners
Fasteners can be used to mount the top or bottom of the control
panel to your vehicle. Before adhering the adhesive side of the
fastener to a surface, clean that surface with isopropyl alcohol.
Use of Hook & Loop simplifies control panel installation.
Control Panel Mounted With Through Dash Bracket
Installation instructions are provided with the bracket. We
recommend using a professional installer if you are not familiar
with customized dashboard installations.
1. Power Port
10/4/00
9:37 AM
Page 17
5. Laser Port
4. Voice Port
3. Radar 2 Port
2. Radar 1 Port
14
INSTALLATION OF CONTROL PANEL
Antenna Cable Connection
The stereo connector (straight end) on the end of the antenna
cable plugs into Radar 1 port (2) on the back of the control panel.
LRM-5 Cable Connection
After mounting the LRM-5, conceal the cable and plug the
stereo jack connector (right angled end) into the port on the
back of the control panel labeled LASER port (5).
Power Cable Connection
The power cable has a plug on one end which connects to the
back of the control panel at the port labeled PWR port (1). At
the other end of the power cable the power and ground wires
are separated. The ground wire has a "U" type connector which
should be fastened to a metal surface. Look for an existing
screw or bolt under the dash to use as a grounding point. The
power wire has a spade type connector which should be connected
to a switched +12 volt DC circuit in your vehicle's fuse box. A
switched circuit is one that has power when your vehicle is on,
but has no power when your vehicle is off. Connect the "U"
type connector to the ground point selected, attach the power
cord plug to the control panel area marked "PWR" then touch
the power wire to the +12 volt DC switched power source
selected; if the control panel sounds the self test sequence,
then all connections are correct.
15
Advertisement
