Table of Contents
Advertisement
INST ALLA TION OF LASERANTENNA
Mounting the Laser Antenna
The laser antenna can be mounted to the front windshield
using the windshield bracket supplied.
Installing the Laser Antenna
Before using, attach the suction cup and rubber bumpers (2)
to the metal bracket. If necessary, you may bend the metal
bracket in order to position the laser antenna correctly (3-lens
array facing forward, single lens facing behind.)
Laser antenna mounted with windshield bracket.
Using Hook & Loop Fasteners, the laser antenna may also be
mounted to the back side of your rearview mirror. Be careful not
to block the rear facing lens when mounted in this manner.
Also, clean the appropriate surfaces with isopropyl alcohol before
adhering the adhesive side of the fastener to those surfaces.
Laser antenna mounted to rearview mirror with Hook & Loop Fasteners.
13
INST ALLA TION OF CONTROL PANEL
General Information
The control panel may be mounted using the Under Dash
Bracket or Hook & Loop fastener supplied. As an alternative,
you may also use the Through Dash Bracket. When choosing a
mounting location, consider your needs for ease of viewing the
display, accessibility of controls (remember Mute Mode may be
used frequently), and concealment.
The control panel can also be mounted on its side and even
upside down! Installation just got a lot more flexible.
Control Panel Mounted With Under Dash Bracket
Fasten the Under Dash Bracket to your vehicle's dash with the
two #4 x 5/8" sheet metal screws provided. A 5/64" drill bit
should be used to drill pilot holes for the screws. Use the holes in
the bracket to mark the location for pilot holes.
Once the bracket is fastened to your vehicle, the control panel
can be attached to it. However, we suggest connecting all cables
to the back of the control panel before snapping it into the bracket.
See page 15 for proper placement of cables.
HIGHWAY
Control panel snaps into rather than slides onto the Under Dash Bracket.
HIGHWAY
14
Advertisement
Table of Contents
