• 3/8" Open End Wrench Tools Required • Electric Drill • Drill Bit: 13/64", 5/16”. 7/64”, 9/64”, and 13/64” Whistler 3500 Components • Other Tools May Be Required Based On Your Vehicle Type Or Requirements For Customized Installation Mounting Brackets...
MOUNTING FASTENERS MOUNTING FASTENERS Reference Description/Use Bolt #10-32 x 1-1/4" • Fastens Large L or Small L Bracket to vehicle support. Bolt Bolt Bolt #10-32 x 1/2" #10-32 x 1/2" #10-32 x 1-1/4" • Fastens Small L to Large L Bracket (optional approach).
INSTALLATION OF RADAR ANTENNA INSTALLATION OF RADAR ANTENNA General Information The radar antenna is waterproof and designed to be mounted at the front of your vehicle. In most vehicles the best mounting location is directly below or behind the bumper. Radar signals will pass through non-metallic materials such as fiberglass and plastic, however, be sure to mount the receiver away from any metal, as it will block the receiver’s antenna.
Page 6
INSTALLATION OF RADAR ANTENNA INSTALLATION OF RADAR ANTENNA The Small L Brackets are fastened to the Large L Bracket using the #10-32 x 1/2" bolts, #10-32 nuts and lock washers. To fasten the Large L or Small L Brackets to your vehicle, mark the supporting structure through the appropriate holes in the Horizontal Mounting brackets, then drill the holes in the supporting structure with a...
INSTALLATION OF RADAR ANTENNA INST ALLA TION OF LASER ANTENNA Mount the antenna to the vehicle such that the ANTENNA Antenna Cable to the Battery window is facing the road surface, sky, right or left of the CAUTION: Always wear safety glasses and exercise caution vehicle, and the reflector has an unobstructed view of the when working near the battery.
INST ALLA TION OF LASERANTENNA INST ALLA TION OF CONTROL PANEL Mounting the Laser Antenna General Information The laser antenna can be mounted to the front windshield The control panel may be mounted using the Under Dash using the windshield bracket supplied. Bracket or Hook &...
Page 9
INST ALLA TION OF CONTROL PANEL INST ALLA TION OF CONTROL PANEL Control Panel Mounted With Hook & Loop Fasteners Laser Antenna Cable Connection After mounting the laser antenna, conceal the cable and plug Fasteners can be used to mount the top or bottom of the control the stereo jack connector into the port on the back of the con- panel to your vehicle.
(brakes, power mirrors/windows, directionals, horn, etc.) • Check condition of vehicle’s electrical system, including The following accessories can be ordered directly from Whistler by calling battery and alternator. 1-800-531-0004 or visit our online store at www.whistlergroup.com • Install a filter capacitor (470mfd. 25 volt or larger capacitor value) where power connection is made.
Need help?
Do you have a question about the 3500 and is the answer not in the manual?
Questions and answers