Capetti Elettronica WineCap Lupo WSD00LP User Manual

1. Description.
The WSD00LP is a datalogger with 2 input channels to acquire light intensity and presence in area, with storage functionality of
samples acquired.
The presence in area is detected also if a single movement occurs. The sampled area will be considered free if no movement will be
detected in a configurable time interval (
Datalogger periodically sends (
( ) and, in "asynchronous mode" (
occupied/free
The device is suitable to perform Building Automation logics as:

light intensity automatic regulation of lighting devices considering the real light flow in environment

environment climatization considering the real "presence in area" status

enlightenment management (
NOTE: causing the radio transmission latency (
) the datalogger is not suitable to manage the automatic light switch-on when the area is occupied.
in the path
2. Device preset and use mode.
a. Wireless Mode:
No setup operation is needed. Typically the system is configured from factory so the device is already associated to the system
basestation. The device is in STANDBY mode (
with the TEST command (
refer to
Otherwise, in case the device is in FACTORY RESET mode (
for connecting to an existing system, in order to associate it, make reference to the "
manual. Is necessary to use the "WineCapManager" software on the PC connected to the basestation that will be coupled with
the device.
b. USB Logger Mode:
For this operation mode, stand-alone with data downloads through USB, the connection with the PC and the
"WineCapManager" running on it is necessary in order to modify the device 's operation mode. The sampling interval must be
CAPETTI ELETTRONICA s.r.l. - Strada Stratta 57
10090 CASTIGLIONE TORINESE - TORINO - ITALY
VAT 04837130014 - Phone 011.981.98.11 - Fax 011.981.98.210
e-mail info@capetti.it - web www.capetti.it
Picture 1 - Product Image
) measured starting from the last movement detected.
10 minutes minimum
configurable interval - 10 minutes minimum
), all the transitions of presence in area status from "free" to "occupied".
if event occurs
) considering the real "presence in area" status.
on/off
it can reach up to few seconds in case of transmission repetitions or if some routers are present
refer to Picture 5 - Status table - Radio signal quality
.).
Installation procedure
refer to
WSD00LP
User Manual
) the light intensity value, the presence in area status
) for which is necessary to start it
Picture 5 - Status table - Radio signal quality
WineCap System - User Manual R30
), that means it's ready
" software
WA0297E_WSD00LP_User Manual_R08
1/9
V4.6