Vivo PP-DKR1B Instruction Manual
Vivo PP-DKR1B Instruction Manual

Vivo PP-DKR1B Instruction Manual

Clamp-on rotating pegboard & accessory holder

Advertisement

Clamp-on Rotating Pegboard
& Accessory Holder
SKU: PP-DKR1B
Instruction Manual
Assembly Video & Product Info
www.vivo-us.com/products/pp-dkr1b

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PP-DKR1B and is the answer not in the manual?

Questions and answers

Summary of Contents for Vivo PP-DKR1B

  • Page 1 Clamp-on Rotating Pegboard & Accessory Holder SKU: PP-DKR1B Instruction Manual Assembly Video & Product Info www.vivo-us.com/products/pp-dkr1b...
  • Page 2 If you do not understand these directions, or if you have any doubts about the safety of the installation, please contact our product support team at 309-278-5303 or help@vivo-us.com for further assistance. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
  • Page 3: Package Contents

    Package Contents B (x2) A (x1) Pegboard Support Post C (x1) D (x1) E (x1) Clamp Straight Hook F (x1) G (x2) H (x2) Loop Hook Bin Hook I (x1) J (x4) Magnetic Clip Magnets Included Hardware & Tools S-A (x6) S-B (x6) S-C (x4) T-A (x1)
  • Page 4: Assembly Steps

    ASSEMBLY STEPS STEP 1 Lift the Spring-Loaded Pin on Support Post (A) and rotate the Post roughly 45°. This will reveal four mounting holes on the now revealed swivel Plate. 45° Spring Loaded Pin Swivel Plate Secure Support Post (A) to Clamp (C) using M4x6mm Screws (S-C) and a Phillips screwdriver. Holding the Spring-Loaded Pin up rotate the Post roughly 45°, then release the Pin to lock the position.
  • Page 5 STEP 2 Install Pegboards (B) onto the front and back Support Post (A) using M6x12mm Screws (S-A), M6 Washers (S-B), and 4mm Allen Wrench (T-A). S-A (x6) S-B (x6)
  • Page 6 STEP 3 Remove the protective film from Pad (D) and apply to the underside of Clamp (C). Secure to desktop by tightening hand bolt.
  • Page 7 STEP 4 Slide the Bin Hook (G) into the back of Bin (H) and secure to pegboard. Attach the remaining Accessories (E, F, I, J) onto the pegboard where desired.
  • Page 8 LAST UPDATED: 12/28/23 REV1 v1.0 Need Help? Get In Touch Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com www.vivo-us.com 309-278-5303 Chat live with an agent! FOR MORE GREAT VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: WWW.VIVO-US.COM VIVO-us @vivo_us...

Table of Contents