Cisco 2851 - Integrated Services Router User Manual page 197

Installing the Cover on Cisco 2811 Routers
To install the chassis cover on a Cisco 2811 router, follow these steps. A number 2 Phillips screwdriver
is required.
Position the cover so that it rests flat on the chassis, with the front (bezel) end of the cover about 1 inch
Step 1
(25 mm) from the front end of the chassis. See
Figure 55
Chassis
Cover
Slide the cover toward the front so that the fingers enter the slots and the cover is fully closed. Press the
Step 2
cover flat against the chassis while you slide the cover closed.
Use a Phillips' screwdriver to install the four screws at the top rear of the cover.
Step 3
OL-5792-04
Cover in Position for Installation
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
Figure 55.
Plastic bezel
Installing the Chassis Cover
Approx. 1 inch
(25 mm)
57