Cisco 2851 - Integrated Services Router User Manual page 162

Installing and Removing AIMs
Check that the AIM is installed correctly on the system board. See
Step 7
Figure 21
If you are finished installing modules, install the cover on the router. See the
Step 8
Cover" section on page
Apply the AIM label to the outside of the chassis as described in the
Step 9
on page
Installing Most AIMs in a Cisco 2811, Cisco 2821, or Cisco 2851 Router
Cisco 2811, Cisco 2821, and Cisco 2851 routers have two AIM connectors—AIM slot 0 and AIM slot 1.
You can install a virtual private network (VPN) encryption AIM or a voice-mail AIM in either slot, but
not in both slots. You can install voice and data compression AIMs and ATM AIMs in both slots.
Note If you are installing an AIM2-CUE-K9 or AIM2-APPRE-104-K9, see the
AIM2-APPRE-104-K9 in a Cisco 2811, Cisco 2821, or Cisco 2851 Router" section on page
Accessory Kit to Use
To install most AIM modules in Cisco 2811, Cisco 2821, or Cisco 2851 routers, use accessory kit number
69-0926-01.
Installation Procedure
To install an AIM in a Cisco 2811, Cisco 2821, or Cisco 2851 router, follow these steps.
If the mounting hardware is already in place on the system board, or if you are replacing an existing AIM,
Note
skip
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
22
Correctly Installed AIM in the Cisco 2801 Router
56.
31.
Step 2 through Step 3.
Figure 21.
"Installing the Chassis
"Applying the AIM Label" section
"Installing AIM2-CUE-K9 or
26.
OL-5792-04