Cisco 2851 - Integrated Services Router User Manual page 163

Locate the AIM connector.
Step 1
Remove the three screws from the system board near the AIM connector that you are going to use.
Step 2
(Figure 22
Figure 22
A
Metal standoff locations
Install the two metal standoffs (included in the accessory kit) in place of the two screws that are labeled
Step 3
A in Figure
For most AIMs, install the plastic standoff
Step 4
Figure
shoulder must be seated tight against the system board. (See
OL-5792-04
shows the screws to remove for AIM installation in AIM slot 1.)
Removing Screws from System Board—AIM Slot 1 Installation Shown
A
System board
22. Use a 1/4-inch nut driver to tighten the standoffs. (See
22. Tighten it firmly with your fingers, or very carefully using a 3/16-inch open-end wrench. The
A
B
B
B
Plastic standoff location
(Figure 23)) in place of the screw that is labeled B in
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
Installing and Removing AIMs
A
A
AIM slot 1
connector
AIM slot 0
connector
Figure 24.)
Figure 24.)
23