Cisco Professional Installation; Site Selection Guidelines; Site Environmental Requirements; Heat Dissipation - Cisco 10008 Hardware Installation Manual

Site Planning

Cisco Professional Installation

Professional installation of the Cisco 10008 router is available through the Cisco Professional Services
group. This includes advance site planning, configuring the router to your requirements, and testing the
installed system.
For more information about professional installation, talk to your Cisco sales representative.

Site Selection Guidelines

The Cisco 10008 router requires specific environmental operating conditions. Temperature, humidity,
altitude, and vibration can affect the performance and reliability of the router. The following sections
provide specific information to help you plan for the proper operating environment.

Site Environmental Requirements

Environmental monitoring in the Cisco 10008 series router protects the system and components from
damage caused by excessive voltage and temperature conditions. To ensure normal operation and avoid
unnecessary maintenance, plan and prepare your site configuration before installation. After installation,
make sure the site maintains the environmental characteristics as shown in
Table 2-1
Environmental Characteristic
Temperature, ambient operating
(short-term operating temperature is limited to
131°F (55C) in compliance with Telcordia GR-63.)
Temperature, ambient nonoperating and storage
Humidity, ambient (noncondensing) operating
Humidity, ambient (noncondensing) nonoperating
and storage
Altitude, operating and nonoperating
Vibration, operating
Vibration, nonoperating

Heat Dissipation

Like all electronic equipment, the Cisco 10008 router chassis and components produce heat when turned
on and operating. You must assess the site's air conditioning capacity, and ensure it can compensate for
the heat dissipation of the system.
chassis with an AC PEM and all line cards installed.
Cisco 10008 Router Hardware Installation Guide
2-2
Cisco 10008 Router Environmental Tolerances
Table 2-2
Minimum
41 degrees F
(5 degrees C)
–40 degrees F
(–40 degrees C)
5 percent
5 percent
–197 ft (–60 m)
—
—
shows the maximum BTUs dissipated by the Cisco 10008
Chapter 2 Preparing for Installation
Table 2-1.
Maximum
104 degrees F
(40 degrees C)
158 degrees F
(70 degrees C)
85 percent
95 percent
13,123 ft (4000 m)
5 to 200 Hz, 0.5 g
(1 octet/min.)
5 to 200 Hz, 1 g
(1 octave/min.)
200 to 500 Hz, 2 g
(1 octave/min.)
OL-0659-13