Overview iMPOrtAnt sAFetY inFOrMAtiOn Thank you for selecting the AWH54/AWH55+ Wireless GenerAl When using your telephone equipment these basic safety precautions and warnings should Office Headset System from Avaya. You have made the be followed to reduce the risk of fire, electric shock, and injury to persons. right choice for comfort and versatility.
AwH55+ setuP 1 AwH55+ setuP 2 AVAYA AVAYA with 40, 410SW, 40, with 410, 40, 5410, 41 D+M 40SW, 41SW, 4SW, 45SW, 40SW and 44 D+M Telephones 540, 510 and 50 Telephones* configuration configuration dial set to 1 dial set to {see pages 4 and 5 for callout of components}...
AwH54/AwH55+ setuP 5 CHArge YOur HeAdset AVAYA with other Telephones Dock the headset into the charge Caution: It is important for correct and safe operation that cradle (1). The amber charge indi- the base cord is installed into the proper jack of your tele- cator (9) will flash during charge.
seleCt YOur HeAdset weAring OPtiOn MAke A test CAll To place a test call press the talk button on the headset. important: If your telephone has a receive volume control ensure Earloop it is set no higher than mid-range–too high a Headset with Tri-Pod (Optional) Uniband Headset setting could cause audio...
sPeAk vOluMe If they cannot hear you at all, try changing your telephone configuration dial on the base to an- other one of its 4 positions until you hear them and they hear you. Volume adjustments can be made separately as described in the next step.
enABle/disABle intellistAnd™ PlACe A CAll using YOur HeAdset When the AWH54/AWH55+ Wireless Headset System is used in conjunction with a Hookswitch To place a call using the headset, the system must be in Control Cord or an AVAYA Telephone Handset headset mode and dial in the normal way.
FeAtures recharge the Headset To recharge the headset, place it into the Out of range Warning charge cradle in the base unit. During charging, the charge indicator As you walk away from the base unit you will eventually reach on the base unit will flash amber. the system operating range limit.
trOuBlesHOOting SYMpTOM SUGGeSTiOn Receive sounds • Move the AWH54/AWH55+ base unit distorted. further away from telephone or computer. SYMpTOM SUGGeSTiOn • If your telephone has a receive volume I cannot hear caller/dial tone. • Check that all cords and jacks control, lower your telephone volume until are connected correctly.
suBsCriPtiOn SYMpTOM SUGGeSTiOn I can hear too much • Lower the speak volume fine The headset and base unit are supplied echo or sidetone. tune (13) on the base unit. subscribed to each other. However, if you • If the volume is still too high, wish to use a replacement headset with lower the speak volume mas- the base unit, then the units must be...
sYsteM reset OPtiOnAl ACCessOries & rePlACeMent PArts To recover from some fault conditions (refer to the Trouble- shooting Section) you may need to perform a system reset. To perform the system reset follow this procedure: DeSCripTiOn 1. Press both the talk button (14) and the mute control (15) button on the headset for 5 seconds.
Page 14
OPtiOnAl ACCessOries FCC reQuireMents & rePlACeMent PArts fCC reqUireMenTS—pArT 15 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two DeSCripTiOn conditions: 1.This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
ACCessing tHe AvAYA uniFied COM- If this telephone equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance MuniCAtiOn Center (uCC) FrOM tHe notice isn’t practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.
Need help?
Do you have a question about the AWH-55 and is the answer not in the manual?
Questions and answers