Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for EK-Quantum Velocity3 1851
Summarization of Contents
GENERAL INFORMATION ON WATER BLOCK COMPATIBILITY
Intel LGA-1700/1851 Compatibility
Specifies compatibility with Intel LGA-1700/1851 CPU sockets.
AMD AM5 Socket Compatibility
Specifies compatibility with AMD AM5 CPU sockets.
WATER BLOCK DIMENSIONS
Intel LGA 1700/1851 Dimensions
Diagram showing dimensional specifications for Intel LGA 1700/1851.
AMD AM5 Dimensions
Diagram showing dimensional specifications for AMD AM5.
TECHNICAL SPECIFICATIONS AND WATER BLOCK PARTS
NICKEL PLEXI Part List
Technical specifications and parts list for the Nickel Plexi variant.
PREPARING THE MOTHERBOARD - INTEL LGA 1700/1851
Step 1: Remove Motherboard
Remove the motherboard from your computer and place it on an even surface.
Step 2: Cleaning the CPU
Wipe the IHS clean using a non-abrasive cloth or Q-tip.
Step 3: Applying Thermal Compound
Apply and spread thermal compound evenly on the CPU IHS.
PREPARING THE MOTHERBOARD - AMD AM5
Step 1: Remove Motherboard
Remove the motherboard from your computer and place it on an even surface.
Step 2: Remove Hold-Down Clamps
Remove the original plastic hold-down clamps securing the socket.
Step 3: Cleaning the CPU
Wipe the IHS clean using a non-abrasive cloth or Q-tip.
INSTALLING THE WATER BLOCK - INTEL LGA 1700/1851
Step 1: Attaching the Backplate
Install the Intel backplate to the back of the motherboard, aligning holes.
Step 4: Applying Thermal Compound
Apply thermal grease evenly on the CPU heat spreader (IHS).
AMD AM5 WATER BLOCK CONFIGURATION
Step 1: Remove Cold-Plate
Remove the cold-plate by unscrewing four M4x14 screws.
Step 5: Port Configuration
Use bottom port as INLET; screw in G1/4 fittings and attach tubes.
INSTALLING THE WATER BLOCK - AMD AM5
Step 1: Attaching Mounting Screws
Install four mounting thumb screws through motherboard to backplate.
Step 2: Attach Mounting Brackets
Slide the AM5 mounting brackets into water block side channel.
CONNECTING THE D-RGB LED
Step 5: Connect LED
Plug the 3-pin D-RGB connector to the motherboard's DRGB HEADER.
Need help?
Do you have a question about the Velocity3 1851 and is the answer not in the manual?
Questions and answers