TYAN TRINITY I7205 Manual page 11

2.6 – ACPI Wake-up Jumper for USB Port-A and Port-B (J13)
2.7 – External SCSI LED Input Jumper (J22) (if optional SCSI included)
2.8 – Clear CMOS Jumper (J28)
CLOSE Pins 1 and 2
Rear panel USB devices' ACPI S1 wake up
CLOSE Pins 2 and 3 (Default)
Rear panel USB devices' ACPI S1/S3/S4
wake up
Total current of all USB devices should not exceed the
standby current rating of the power supply
Pin-1
External SCSI LED Input
Pin-2
GND
Clear
You can reset the CMOS settings by using this
jumper when you
§ Have forgotten your system/setup password
§ Need to clear system BIOS setting
- Power off system and disconnect power
supply from AC source
- Use jumper to close JP28 for several
seconds to Clear CMOS
- Take off jumper from JP28 (default setting)
- Reconnect power supply to AC source
- Power on system
- Use "F2" key to go into system BIOS setup
11
http://www.tyan.com
pin-1
pin-1
Default