Integrated Peripherals - TYAN TOMCAT IVS D Manual

4.9 Integrated Peripherals

IDE HDD Block Mode
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
On-Chip Primary PCI-IDE
On-Chip Secondary PCI-IDE :Enable
PCI Slot IDE 2nd Channel
On-Board FDC Controller
On-Board Serial Port 1
On-Board Serial Port 2
On-Board Parallel Port
Parallel Port Mode
w Onboard FDC Controller
This option lets you enable or disable the onboard floppy controller.
The default is enabled.
w Onboard Serial Port 1/2
This option lets you select how this port will be addressed. The options
are Com1 thru Com4 or disabled.
The default is Com1for port 1 and Com2 for port 2.
w Onboard Parallel Port
This option lets you select the LPT port address. Options are
3BC/IRQ7, 378/IRQ7, 278/IRQ5 or Disabled.
Note: Cannot use EPP or ECP+EPP when using 3BC/IRQ7
The default is 378/IRQ7.
w Parallel Port Mode
This option lets you select which mode the parallel port will run in. The
options are Normal, EPP, ECP, or ECP + EPP.
Normal- Standard parallel port mode.
EPP - Bi-directional mode.
ECP - Fast, buffered mode.
EPP/ECP- Bi-directional and buffered.
Check the documentation of your device to see how it needs to be set.
The default is Normal.
S1564-001-01 www.tyan.com
Integrated Peripherals
Award Software, Inc.
:Enabled
:Auto (See page 43 for IDE settings)
:Auto
:Auto
:Auto
:Enable
:Enable
:Enable
:Com1/3F8
:Com2/2F8
:378/IRQ7
:Normal
42