TYAN TOMCAT H1000S Manual page 27

Type B: SCREW RETENTION TYPE HEATSINK
Finishing Installing the Heatsink
After you finish installing the heatsink onto the processor and socket, attach the end wire of
the fan (which should already be attached to the heatsink) to the motherboard. The
following diagram illustrates how to connect fans onto the motherboard.
1. After placing CPU back-plate and
adhesive interface material under
motherboard, place heatsink retention
frame on top of motherboard. Align
heatsink retention frame screw hole with
backplate assembly standoffs. Place
heatsink inside plastic retention bracket.
Place metal clip over retention frame
tab. Repeat this action on the other side.
2. Insert screw through metal clip.
BE SURE METAL CLIP IS LOCKED
ONTO RETENTION FRAME TAB.
3. Tighten screw through metal clip.
Repeat this action on the other side.
DO NOT OVER TIGHTEN.
After you've finished installing all the
fans you can connect your drives
(hard drives, CD-ROM drives, etc.)
to your motherboard.
27
http://www.tyan.com