TYAN Titan Turbo S1573S ATX-2 Manual page 65

HARD DISK INSTALL FAILURE
Cannot find or initialize the hard drive controller or the drive. Make sure
the controller is installed correctly. If no hard drives are installed, be
sure the Hard Drive selection in Setup is set to None.
Hard disk(s) diagnosis fail
The system may run specific disk diagnostic routines. This message
appears if one or more hard disks return an error when the diagnostics
run.
Keyboard error or no keyboard present
Cannot initialize the keyboard. Make sure the keyboard is attached
correctly and no keys are pressed during POST. To purposely configure
the system without a keyboard, set the error halt condition in Setup to
Halt On All, But Keyboard. The BIOS then ignores the missing key-
board during POST.
Keyboard is locked out - Unlock the key
This message usually indicates that one or more keys have been
pressed during the keyboard tests. Be sure nothing (including your
hand) is resting on the keyboard.
Memory Test :
This message appears during a full memory test, and counts down the
memory areas to be tested.
Memory test fail
If POST detects an error during memory testing, additional informa-
tion appears, giving details about the type and location of the memory
error.
Override enabled - Defaults loaded
If the system cannot boot using the current CMOS configuration, the
BIOS can override the current configuration with a set of BIOS
defaults designed for the most stable, minimal-performance system
operations.
65