Installation - Kenwood KTC-HR200 - HD Radio Tuner Box Instruction Manual

InstaIlation
Connecting Wires to Terminals
~
~
• The unit can only be connected to a control
unit with either SL or KAB connector.
• Control Unit
'-~t---~
(KAB connector)
~
Accessorv(2)
======~r"~
. -
O/'f\N3~
Antenna Cable (AccessoryG))
C~~P:CI
I]
To FM/AM antenna '
KTC-HR200
~.
I
Control Unit
L~
-----,
(5L connector)
Keep "SELECT SWITCH" 2 down.
If you set the switch up (ON), the unit does
not operate normally.
KAB Connector units
KVT-512, DDXS12, DNXS 120, DNXS12EX,
DDX812, DDX712, DNX8120, DNX7120
(As of April, 2008)
~
~
Set "SELECT SWITCH" 1 depending on a
connector type of a control unit to be
used.
When connecting to the control unit
with 5L connector, set this switch down,
and when KAB connector set the switch
up (ON).
SELECT SWITCH
IQ6rr
SL
Installation
Remove the backing from the velcro strips
(Accessory@) and attach it to the bottom of the unit.
Install the switching unit on the carpet.
Lt
• Please do not install the unit near the dashboard, the rear
tray, or other important components. Doing so could lead
to injury or accident should the unit come off due to a
shock and strike a person or an important component.
@2
• Do not stick the velcro tape over the serial number.
English
I En-1S