Ide Primary/Master/Slave Setup - TYAN TEMPEST I5000PW Manual

3.2.1 IDE Primary//Master/Slave Setup
Computer detects IDE drive type from drive C to drive D.
Press Enter on any of the Primary/Master, Primary/Slave, options to view
advanced details of the corresponding drive. The system displays advanced
details like the number of heads/cylinders/sectors on the detected disk and the
maximum storage capacity of the disk.
Main
Type:
LBA Format
Total Sectors
Maximum Capacity
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
Ultra DMA Mode:
F1 Help
Setup Defaults
Esc Exit
Previous Values
The system displays advanced details like the number of
heads/cylinders/sectors on the detected disk and the maximum storage capacity
of the disk.
This option lets you set the following hard disk parameters:
Type
Selects the type of device connected to the system.
Auto / CD/DVD / Not Installed / ARMD
Multi-Sector Transfers
This option allows you to specify the number of sectors per block for multiple
sector transfers.
16 Sectors / 2 Sectors / 4 Sectors / 8 Sectors /Disabled
LBA Mode Control
Enables or disables LBA Mode.
PhoenixBIOS Setup Utility
Advanced
[Auto]
xxxxxxxxx
xxxxxxx
[16 Sectors]
[Enabled]
[Disabled]
[FPIO 4 / DMA 2]
[Mode 5]
↑↓
Select Item
← →
Select Menu
http://www.TYAN.com
Power
Exit
Item Specific Help
User = your enter
parameters of hard-disk
drive installed at this
connection.
Auto = autotypes
hard-disk drive installed
here.
1-39 = you select
pre-determined type of
hard-disk drive installed
here.
CD-ROM = a CD-ROM
drive is installed here.
ATAPI Removable =
removable disk drive is
installed here.
-/+ Change Values
Enter Select
45
Boot
F9
Sub-Menu F10