Document Is Not Printed Correctly - Kyocera KM-F1060 Operating Instructions Manual

Document is Not Printed Correctly

Problem
Incorrect printing position or printing
is missing at the edge.
Characters and symbols not used in
documents are printed.
Printing operation takes excessive
time.
Although print data is transferred to
the device, it is not printed.
Printing stops in the middle of the
run.
Possible Cause / Solution(s)
• Paper size or printing orientation is different between the application settings
and the printer driver settings - Specify the settings again.
• The specified paper has not been loaded in the device - Specify the settings
again or load the appropriate paper.
• The document margin is not sufficient. On the machine, a margin of approx. 0.2
inches (5 mm) or more is required at the sheet edges. (Recommended printing
margin) - Adjust the margin correctly.
Verify that the correct machine has been selected by users as the printer driver.
The wait time for printing operations depends on the spool settings.
• Reference :
Windows 98/Windows Me
Windows NT 4.0
Windows 2000/Windows XP/Windows Server 2003
• Make sure the printer is on line.
• Make sure the device is not in the Shutdown Mode. Press ENERGY SAVER
key to return to standby mode. See the Operating Instructions for Copier &
Network Scanner for details.
• Make sure the USB printer cable is connected properly.
• Restore the power if the ON LINE LED is Off even if the USB printer cable is
connected.
• Check if there is a Network problem.
[Details Tab] (See page 43)
[Scheduling Tab] (See page 52)
[Advanced Tab] (See page 62)
217