Convenient Functions; Channel Level; Fader Function; Quick Select Function - Denon AVR-2808 Owner's Manual

Convenient Functions

Channel Level

You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
1
CH SELECT
Press .
Channel Volume
FL 0.0dB SR
C 0.0dB SBR
FR 0.0dB SBL
SW 0.0dB SL
Fader
FRONT : REAR
2
CH SELECT
Use ui or to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use o p to adjust the volume.
b "OFF" can be set by pressing o when the subwoofer's volume is
set to –12 dB.

Fader Function

This function lets you adjust (fade) the sound from all the front or
rear speakers at once.
1
CH SELECT
Press .
2
CH SELECT
Press ui or to select "Fader".
3
Use o p to adjust the volume of the speakers.
(o: front, p: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.

Quick Select Function

With this function, the currently playing input source, input mode,
surround mode, room EQ settings and volume can be stored in
the memory.
1
Set the input source, input mode, surround mode,
room EQ settings and volume to the conditions you
want to store.
2
Press and hold the desired
0.0dB
0.0dB
Keep pressing the button until the quick select indicator lights.
0.0dB
0.0dB
Quick Select 1
Quick Select 2
Quick Select 3
• To call out the settings, press QUICK SELECT at which the desired
settings were stored.
• The Quick Select name can be changed (vpage 32).
NOTE
Input sources stored with the quick select function cannot be selected
if they have been deleted at menu "Manual Setup" – "Option Setup"
– "Source Delete" (vpage 31). In this case, store them again.

Personal Memory Plus Function

This function sets the settings (input mode, surround mode, etc.)
last selected for the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
The surround parameters, tone control, room EQ settings and the
volumes of the different speakers are stored for the individual surround
modes.
QUICK SELECT
.
[Quick Select Defaults]
Input Source Volume
DVD –40 dB
TV/CBL –40 dB
VCR –40 dB

Last Function Memory

This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.

Backup Memory

The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.

Resetting the Microprocessor

Perform this procedure if the display is abnormal or if operations
cannot be performed.
When the microprocessor is reset, all the settings are reset to
their default values.
1
<POWER>
Turn off the power using
2
<POWER>
Press while simultaneously pressing
<STANDARD> <DSP SIMULATION>
and
3
Once the display starts flashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
.
.
0