Multi-Zone Operations; Turning The Power On And Off; Selecting The Input Source; Adjusting The Volume - Denon AVR-2808 Owner's Manual

<ZONE2/3 / RECSELECT>
<ZONE3 ON/OFF>
SOURCE SELECT <ZONE2 ON/OFF>
[ AMP]
[ON]
[OFF]
(ZONE2
mode)
VOLUME
[MUTE]
SOURCE
SELECT
(Main remote control unit)
[OFF]
(Sub remote control unit)
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit

Multi-zone Operations

VOLUME

Turning the Power On and Off

GOperation on the main unitH
Press <ZONE2 ON/OFF> or <ZONE3 ON/OFF> for the zone to be operated.
When the power turns on, the multi-zone indicator (
lights on the display.
GOperation on the remote control unitH
In the zone mode you want to operate, press [ON] or [OFF].

Selecting the Input Source

GOperation on the main unitH
q Press <ZONE2/3 / REC SELECT> and select the zone to be adjusted.
w Turn <SOURCE SELECT>.
[ON]
GOperation on the remote control unitH
In the zone mode you want to operate, press [SOURCE SELECT].
[OFF]
(ZONE3
mode)

Adjusting the Volume

GOperation on the main unitH
q Press <ZONE2/3 / REC SELECT> and select the zone to be adjusted.
w Turn <VOLUME> to adjust.
GOperation on the remote control unitH
In the zone mode whose volume you want to adjust, press [VOLUME].
[Variable range]
The volume can be adjusted when menu "Manual Setup" – "Zone
Setup" – "(select the zone)" – "Volume Level" is set to "VAR" . The
volume can be increased up to the value set at menu "Manual Setup"
– "Zone Setup" – "(select the zone)" – "Volume Limit" (vpage 30).
[ON]
SOURCE SELECT
VOLUME
[MUTE]
or
– – – –70dB ~ –40dB ~ +18dB

Turning off the Sound Temporarily

In the zone mode for which you want to mute the sound, press
[MUTE].
The sound is reduced to the level set at menu "Manual Setup" – "Zone
Setup" – "(select the zone)" – "Mute Level" (vpage 30).
To cancel, either adjust the volume or press [MUTE] again.
) The setting is canceled when the zone's power is turned off.
The source selected for ZONE2 is also output from the recording
output connectors.
NOTE
• When the input source to which the digital input connectors
(OPTICAL/COAXIAL) are assigned is selected in ZONE2 or ZONE3,
playback is only possible if the digital signal being input is in PCM
(2-channel) format.
• Digital audio signals input from the HDMI connectors cannot be
played in multi-zone.
• When certain digital signals are being input, noise may be output
from the ZONE2 and ZONE3 audio output connectors.
0